Upgrade prerequisites for inSync Storage Node


Hardware prerequisites
The Hardware prerequisites table lists approximate numbers, which are dependent on various factors. To know the exact hardware prerequisites for your enterprise, contact Druva Support.
The following table lists the hardware prerequisites to upgrade inSync Storage Node.
Hardware | Minimum requirements | |||||
---|---|---|---|---|---|---|
CPU | 64-bit, quad core processor | |||||
RAM | 8 GB RAM for up to 1 TB of storage. If you have storage above 1 TB, we recommend that you add 1 GB RAM per additional TB of storage. |
|||||
Disk space required for logs |
1,000 Users | 5,000 Users | 10,000 Users | 25,000 Users | 50,000 Users | 100,000 Users |
175 GB | 275 GB | 400 GB | 600 GB | 900 GB | 1500 GB |
Note: inSync does not support disks formatted with sector size greater than 512 bytes.
To know the sector size on a Windows system, run the following command on the Windows command prompt.
fsutil fsinfo ntfsinfo <Drive letter>
For example: fsutil fsinfo ntfsinfo D:
Software prerequisites
The following table lists the software prerequisites to upgrade inSync Storage Node.
Software | Minimum Requirement |
---|---|
Operating system |
|
Web browser |
|
Other prerequisites
The following table lists the other requirements to upgrade inSync Storage Node.
Requirement | Description |
---|---|
Open port numbers |
This port is used to communicate with the inSync Master. By default, inSync Master uses the following ports:
Note: |
IP address or FQDN | The WAN IP address or FQDN for backing up data over WAN. You can configure the IP address by using the inSync Master Management Console. |